SOLID™ FACTS
SOLID RACKS are 100% manufactured in Australia using only the highest quality materials and finishes.
SOLID RACKS backboards are constructed from High Moisture Resistant Melamine Board with a 2mm thick ABS (Acrylonitrile Butadiene Styrene) edge. This ABS compound is environmentally friendly, high heat resistant, recyclable and non-toxic.
SOLID RACKS solid hardwood timber rods are rebated, screwed and glued for optimal strength and have been thoroughly weight tested to hold up to 17kgs per 2 horizontal supports. The heaviest single Mal weighs around 10kgs.
SOLID RACKS foam stands alone as the most resilient high-density memory foam available to provide the highest grade of protection for your most precious possession.
SOLID RACKS hold either 4 boards horizontally or 8 boards vertically.
SOLID RACKS can also accommodate 8 boards horizontally (not weighing more than 17kgs in total) per two horizontal supports and up to 16 boards vertically in cases where the fins are detachable.
SOLID RACKS also come in 6's, 12's and 24's for the Professional Surfer.
SOLID RACKS™ Installation Instructions
SOLID Fastening Kit with Safety Tie Offs Included.
STEP 1
Masonry Walls
Apply a spirit level to attain level installation. Using a 5.5mm drill-bit, hammer-drill pilot holes into masonry wall avoiding any soft render joints. Fit plastic wall plugs & trim flush. Screw SOLID RACKS into place with supplied self-tapping screws.
Gyprock Walls
Apply a spirit level to attain level installation. Using a 3mm drill-bit, drill pilot holes centre of timber wall studs and screw SOLID RACKS into studs with supplied self-tapping screws.
If timber studs cannot be located seek professional advice for safe installation.
STEP 2
Plastic Caps
Push supplied SOLID white plastic caps into screw heads
Tie Off Safety Fastenings
SOLID RACKS stainless steel saddle fastenings are an optional extra to enable your boards to be tied off at either end for added safety, stability and maximum protection.
STEP 3
Drill small pilot holes centred off edges with a 2mm drill-bit. Screw in SOLID RACKS stainless steel saddle fastenings with supplied screws at top, face or sides of backboard. Thread your own 6mm soft cord through saddles and tie off at either end or where required. An elastic hockey strap may also be used.
Note: The soft cord or elastic hockey strap must not be tied too firmly. The optimum stringing and tying off of the cord should not be over stretched.
ATTENTION: Do not over stretch or tighten.
If doubling-up boards with detachable fins, adequate padding between boards is essential to prevent damage.
WARNING: If SOLID RACKS are loaded above 30kgs Dynabolts or Chem-Set fastings MUST be purchased & installed STRICTLY as directed by fastening manufacturer's instructions.
You may also consider
